Ricoh / Savin Error Codes
Ricoh 2700/3700 ram clear(a/k/a Savin 3640/3680)
Press function 6 1 9 9 5 yes
Press 0 1 yes (bit 7 is displayed on left, bit 0 on right)
Press * or # to scroll through the menu
Note: right arrow is increment switch and left arrow is decrement switch
Perform Reset Level 2 to clear all data by setting system switch 00, bit 1 to 0 and bit 0 to 1 [00000001]
After erasure, bits will be reset to 0, then turn the machine off.
Ricoh 20E SET SENSOR error: This may be an indication that the memory backup battery is failing, since the sensor levels are set in the service mode from the operation panel and stored in memory by a 3v lithium cell. To reset the sensor, pull the paper through the cutter and out the front till it hangs down a few inches. Then hold the STOP button while powering it up. The display will read ENABLE SERVICE FUNCTION. Release the STOP key and quickly press START then VOICE REQUEST then START. The display should read SET VALUE OF SENSOR and the paper will feed and cut. If it doesn't, then try again and press quickly. If this doesn't solve the problem, then the blades are warped, or the cutter driver is bad. If the battery is failing, you will need to repeat this process when the FAX is unplugged or the power is interrupted.
Ricoh Type 30 machines: See Omnifax L40 series machines
Ricoh Type 150 machines: See Omnifax L525,535,545
<<
^
>>
|
